How to clean the shower cabin at home: a description of the

16-06-2018
Sewage

The shower cabin must be kept in perfect purity, because you are in contact with its surface with bare areas of the body in the process of receiving water procedures. And if, due to the abundance of dirt, pathogenic germs appear, this can significantly harm your health.

In this article we will consider the full range of the necessary cleaning work done by yourself.

Removing dirt from the glass door of the shower

Process description

Instructions cleaning the shower stall is as follows:

Stage 1: preparation

Photos of items that will disturb you in the process of cleaning

For personal hygiene, a lot of aids such as shampoos, soaps, toothpastes and brushes, razors, various gels and creams are used. So, they need to be collected and temporarily removed from the cleaned area so that they do not interfere with you. Moreover, under the bottles and cans there are very often formed various kinds of influx and mud stains, which also must be removed.

Stage 2: elimination of surface dirt

Good pressure from the shower head makes it easy to wash off traces of surface dirt.
  1. Switch the mixer to the shower.
  2. We expose the hot water and the maximum pressure.
  3. We roll back the walls and the floor of the construction from the watering can, washing the hair and other large garbage into the drain hole.

Stage 3: Mold Removal

Mold Spread in the Shower

Now let's look at how to clean the shower cabin from mold, which not only interferes with its aesthetic appearance, but also can harm your health:

  1. We buy mold spray in a specialty store.
Mold Spray Example
  1. Apply it to problem areas.
  2. We are waiting for some time in accordance with the attached annotation.
  3. Rinse thoroughly with water from a watering can.

Advice: when using the above remedy, it is recommended to wear rubber gloves on your hands, since getting it on unprotected skin can cause chemical burns.

Sample rubber gloves

If the price of the store solution seems too high to you, then you can prepare it yourself. To do this, you need the following ingredients:

Title amount
Vinegar 1 cup
Baking soda ? glasses
Ammonia 1 cup
Hot water 5 liters
Soda is one of the components of a homemade solution that removes traces of mold.

Tip: be sure to wipe the walls after removing the mold dry to avoid its reappearance.

Stage number 4: the removal of yellow raid

Harmless means of removing various deposits

At this stage, let's figure out how to clean the shower cabin with citric acid from yellow bloom:

  1. Knead the solution of the following ingredients:
Component amount
Lemon acid 20 g
Water 1 cup

Tip: It is recommended to use hot water. This will allow the powder to dissolve faster.

  1. Pour the mixture into a spray.
An example of a suitable spray
  1. Sprinkle contaminated places.
  2. After 10 minutes, wash off and observe a clean surface.

A special advantage of this composition is its harmlessness.

Stage 5: cleaning the glass

Glass cleaner

In the shower glass doors and even walls can be glass. Their pollution spoils the whole appearance of the structure. Therefore, this material should be approached responsibly enough.

So, how to clean the glass shower?

You can go two ways:

  1. Apply chemical solutions, while paying attention that they do not contain in their composition abrasive substances that can damage the surface of the material.
  2. Use mechanical methods:
  • Scrapers and brushes, allowing for a snug fit to easily remove a layer of dirt.
Scraper for removing stains from the glass surface
  • Melamine sponge.
Melamine Sponge Sample
  • Steam cleaner. It is rather expensive equipment, but it saves you forever from searching for an answer to the question: how to clean the shower cabin from soap stains and other mud deposits?
Steam cleaner with different nozzles

Stage number 6: processing watering can

Watering can in acetic solution

The accumulation of lime in the sieve of watering can can lead to a drop in its productivity.

In order to avoid this it is necessary:

  1. Pour water and vinegar into a small container.
  2. Unscrew the watering can neatly.
  3. Place it in the mixture overnight.

In the morning, you will replace the already clean and properly working device.

Stage №7: cleaning the drain hole

Hair removal from the shower cabin drain

How to clean the blockage in the shower yourself?

To do this:

  1. Unscrew the siphon.
  2. Take a thin needle or wire and remove from the drain all the hair stuck there, as they are the cause of the plug in the shower drain.
  3. Connect all back.

Conclusion

Maintaining cleanliness in the shower is very important, since not only the attractiveness of its appearance, but also the safety of your health depends on it. By completing the 7 steps above, you can do away with any kind of pollution.

A clean cabin is a guarantee of the beauty of the bathroom and the health of users.

The video in this article will introduce additional materials. Keep the site of the water treatment clean.